Whilst I was doing banners I thought I'd progress with the titan groin banner, these were printed off by Drake Seta (Battle Bunnies Blog) and adapted from the Reaver banner, name blanked out and a few markings blanked out to be different from the other banners. The finials were from the plastic skulls set and the chain is steel so they stick to the magnets on the groin of the titan. The banner was finished off with some washes at the bottom to show wear and tear. The paper was wrapped around a rivet pin and glued with watered down PVA which also stiffens the paper and keeps the fold.
16 Sept 2024
Legio Astorum Forge World Warbringer Nemesis Titan - WIP #3 - Banners
Whilst I was doing banners I thought I'd progress with the titan groin banner, these were printed off by Drake Seta (Battle Bunnies Blog) and adapted from the Reaver banner, name blanked out and a few markings blanked out to be different from the other banners. The finials were from the plastic skulls set and the chain is steel so they stick to the magnets on the groin of the titan. The banner was finished off with some washes at the bottom to show wear and tear. The paper was wrapped around a rivet pin and glued with watered down PVA which also stiffens the paper and keeps the fold.
9 Sept 2024
Legio Astorum Forge World Warbringer Nemesis Titan - WIP #2 - Legs
The elastic bands keep the seal whilst the two part epoxy dries, I am using JB Plastic Weld again, its superb. The pin to the knee gears can be seen above. The slot is where the knee armour gets placed.
I preserved the flames from one thigh armour plate, but painted blue - this echoes the flames on the toe piston armour and one of my vassal Imperial Knights. I like to preserve and adapt the previous history of my rescue Titans.
6 Sept 2024
Lord TITANium - Warlord Titan #2 - Psi-Titan WIP
Hello one and all!
Up this week for your viewing is my next Warlord Titan, however I'm pushing the boat out and going all in for a PSI TITAN at 28mm scale. For this, I will be doing bespoke 3D printed parts for the Titan, including armour plates, weapons and psi-matrix crown, as FW/GW do not support 28mm Titans fully.
The build was ok, with the model pinned in all the places possible to help support the model. I have printed a portion of a 28mm printed Warmaster carapace for the Titan to be standing on.
I've opted for a colourshift paint for the armour panels, using a matt black base, then a gloss, then several passes with the colourshift. The plates will also have silver trim, which I think will fit better than a gold scheme.
So far the model has Apoc Missiles for the carapace, but I might also print some Gatling Blasters if the Titan is to be used 'more upclose'
I've also printed a Heavy Volkite and a C-Beamer for the model, as well as a CC option.. more to follow soon.
LH